NeuroTherm NT1100 Operator's Manual page 48

SITE LABELS
From the welcome screen Press "Accept" to get to the Procedure Screen, at the procedure
screen select "Site Labels"
A site labels function is incorporated into the NT1100 that will allow the Doctors to identify each
site that is to be lesioned Up to eight sites labels can be identified per session. Once a site label
has been created for the procedure, it will appear on the stimulation and lesion screens, and will
be incorporated into the printed reports and exported files.
NOTES
•
The generator defaults to the value last entered for each site label. If "C4 RS" was
entered for site 2 during the patients last session, then that will be the value for site 2 until
it is changed,
•
On the touch screen the labels are displayed as numbers, not the entered value. So site 2
will be displayed as "site 2" rather than "C4 RS". Site labels are displayed below the
graphics for stimulation and lesion.
•
The number of site labels available per session depends on the selected procedure. Thus
if a two or three electrode procedure is selected then only two or three sites can be
labelled, respectively. However, single electrode procedures can use all eight site labels.
Enable site labels
To add a label to a patients profile. On the procedure settings screen select the desired
electrode from the pull down menu press "Accept". Select the Site Labels. And the
programming screen will appear as shown below
Select each label option in turn; change the displayed name to the appropriate
designation for the procedure. Change site 1 to C4 RS to indicate 4
the right hand side. Select Accept to enable the updated site labels. The procedure
screen settings will appear. Continue with the procedure as desired
Document 109.00
NEUROTHERM RADIO FREQUENCY LESION GENERATOR
MODEL NT1100
OPERATORS MANUAL
®
10September2012 Issue 06
7-4
th
cervical vertebra on