NeuroTherm NT1100 Operator's Manual page 41

You will then be returned to the "Procedure Setting" Screen. Single Electrode RF will be
selected in the electrode box. Under the electrode box there is a table illustrating which sockets
require an electrode to be used for the given procedure. For single electrode RF socket 1 and the
dispersive lead are labelled 'active', for use in this procedure.
On the right hand side of the screen are all of the operating parameters for the various modes
on the NT1100. At this stage we will use the default parameters. Press "Accept" to go to the
Motor/Sensory screen.
Connecting the dispersive lead
You may now plug in a dispersive lead into the far left socket on the front of the unit
labelled 'Dispersive' and plug in an electrode into Socket 1.
Document 109.00
NEUROTHERM RADIO FREQUENCY LESION GENERATOR
OPERATORS MANUAL
®
MODEL NT1100
Operating
parameters
.
10September2012 Issue 06
6-14