FP PostBase One Operator's Manual page 165

Connect the power sealer to the franking machine
Key holes
Appendix – Moving the PostBase One to another location
Warning: Mind Your Hands! Be very careful
when handling the power sealer. As a conse-
quence of its construction design, the power
sealer has very sharp edges that might hurt
you.
• Position the power sealer on the connector
while inserting the two pegs of the power
sealer into the key holes of the right side
wall of the franking machine.
• Push the power sealer down as far as it
goes. Make sure that the letter guide faces
of both the franking machine and the power
sealer are flush at the upper side.
• Insert the connection cable of the power
sealer into the 9-pin interface on the right
side wall of the franking machine and
tighten screws.
165