FP PostBase One Operator's Manual page 140

Digital franking system
Hide thumbs Also See for PostBase One:
Table of Contents

Advertisement

140
PostBase One Franking System
Issue
PostBase One warns you
about an empty sealant tank,
although there is still enough
sealing liquid in the tank.
...
with using the FP software
Connection to FP software
cannot be established.
Other errors ...
Possible cause and remedy
Tap water might produce air bubbles (depending
on the water quality of your local water supply),
which may interfere with correct filling level detec-
tion.
On the sealer: Open the lid. Pull out the yellow
plug. (See page 123.)
The filling level sensor is located front-right of the
inner side of the tank. Using a finger, wipe over the
sensor several times.
Close the sealant tank. Close the lid.
(See page 124.)
If problem persists: Use 'sealit' sealing liquid or dis-
tilled water.
Check if PostBase One displays the Home screen.
Check if the USB cable is plugged properly.
For further help please refer to the manual of the
FP software in use.
If you cannot remedy an error yourself, please
contact FP aftersales service.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PostBase One and is the answer not in the manual?

Table of Contents