Ipv6 Pim Commands - Edge-Core ECS4620-28T Quick Start Manual

Chapter 51
| Multicast Routing Commands
PIM Multicast Routing
show ip pim rp-hash

IPv6 PIM Commands

This command displays the RP used for the specified multicast group, and the RP
that advertised the mapping.
Syntax
show ip pim rp-hash group-address
group-address - An IP multicast group address.
Command Mode
Privileged Exec
Example
This example displays the RP used for the specified group.
Console#show ip pim rp-hash 224.0.1.3
RP address : 192.168.0.2/32
Info source : 192.168.0.2/32, via (null)
Console#
Table 40: show ip pim rp-hash - display description
Field
RP address
Info source
This section describes commands used to configure IPv6 PIM dynamic multicast
routing on the switch.
Table 41: PIM-DM and PIM-SM Multicast Routing Commands
Command
Shared Mode Commands
router pim6
ipv6 pim
ipv6 pim hello-holdtime
ipv6 pim hello-interval
ipv6 pim
join-prune-holdtime
ipv6 pim lan-prune-delay
ipv6 pim override-interval
ipv6 pim propagation-delay
Description
IP address of the RP used for the specified multicast group
RP that advertised the mapping, and how the RP was selected
Function
Enables IPv6 PIM globally for the router
Enables PIM-DM or PIM-SM on the specified interface
Sets the time to wait for hello messages from a
neighboring PIM router before declaring it dead
Sets the interval between sending PIM hello messages
Configures the hold time for the prune state
Informs downstream routers of the delay before it prunes a
flow after receiving a prune request
Specifies the time it takes a downstream router to respond
to a lan-prune-delay message
Configures the propagation delay required for a LAN prune
delay message to reach downstream routers
– 1188 –
Mode
GC
IC
IC
IC
IC
IC
IC
IC