Installing The Step 7-Micro/Win Software - Siemens Simatic S7-200 System Manual

Installing and Using the STEP 7-Micro/WIN Software
3.1

Installing the STEP 7-Micro/WIN Software

Pre-Installation Instructions
Before running the setup procedure, do the following:
If a previous version of STEP 7-Micro/WIN is installed, back up all STEP 7-Micro/WIN
projects to diskette.
Make sure all applications are closed, including the Microsoft Office toolbar.
Installation may require that you restart your computer.
Installation Instructions for Windows 3.1
If you have Windows 3.1 (Windows for Workgroups 3.11) on your machine, use the following
procedure to install the STEP 7-Micro/WIN 16 software:
1. Start by inserting Disk 1 in the disk drive of your computer (usually drive A or drive B).
2. From the Program Manager, select the menu command File
3. In the Run dialog box, type a:\setup and click "OK" or press
setup procedure.
4. Follow the online setup procedure to complete the installation.
Installation Instructions for Windows 95 or Windows NT 4.0
If you have Windows 95 or Windows NT 4.0 on your machine, use the following procedure to
install the STEP 7-Micro/WIN 32 software:
1. Start by inserting Disk 1 in the disk drive of your computer (usually drive A or drive B).
2. Click once on the "Start" button to open the Windows 95 menu.
3. Click on the Run... menu item.
4. In the Run dialog box, type a:\setup and click on "OK" or press
setup procedure.
5. Follow the online setup procedure to complete the installation.
6. At the end of the installation, the Install/Remove Modules dialog box appears
automatically. See Figure 3-1. You can install the hardware for your machine to
communicate now (see Section 3.2), or you can wait until later (see Section 3.3).
3-2
Run...
. This starts the
ENTER
ENTER
S7-200 Programmable Controller System Manual
C79000-G7076-C230-02
. This starts the