Siemens Simatic S7-200 System Manual page 40

Installing and Using the STEP 7-Micro/WIN Software
Setting Up Communications within STEP 7-Micro/WIN
Within STEP 7-Micro/WIN there is a Communications dialog box that you can use to
configure your communications setup. See Figure 3-6. You can use one of the following
ways to find this dialog box:
Select the menu command Setup
Create a new project and click the "Communications..." button in the CPU Type dialog
box.
If you have a project open, select the menu command CPU
"Communications..." button in the CPU Type dialog box.
STEP 7-Micro/WIN
Project View CPU Setup Help
Communications
Current Communication Settings
Module Parameter
Figure 3-6 Setting Up the Communications between Programming Device or PC and the CPU
After you have called up the Communications dialog box, click the "PG/PC Interface..."
button. The Setting the PG/PC Interface dialog box appears. See Figure 3-7.
3-10
Communications....
PC/PPI cable (PPI)
Local Station Address
Transmission Rate
COM Port
Remote Station Address 2
S7-200 Programmable Controller System Manual
Type... and click the
PG/PC Interface...
Modem Setup...
0
9.6 kbps
2
Test Setup
Close
C79000-G7076-C230-02