Siemens Simatic S7-200 System Manual page 96

Additional Features of STEP 7-Micro/WIN
Formatting the Embedded Data Value
Figure 5-10 shows the dialog box where you define the parameters of the value to be
displayed. The format and options you specify are written to a format word (two bytes) that
precedes each embedded value. Select the size, display format, number of decimal places,
and other options for the embedded data variable.
Embedded Data
Note: Some fields
appear according
to options chosen.
Figure 5-10
Figure 5-11 shows the message dialog box after you have selected the parameters for an
embedded data value. The grayed fields are the place holders for the data value. If you
specified that a user must acknowledge each message, then the acknowledgement
notification bit is displayed in the message dialog.
TD 200 Configuration Wizard
Note: Gray fields are
place holders for
embedded data values.
Figure 5-11
5-10
Data Format: Display Format:
None
Word
Double Word
User must acknowledge message
Is the user allowed to edit this data?
Should the user edit of data be Password-protected?
Delete
TD 200 Message Embedded Data Dialog
You have asked to configure 1 message(s). Define your message by
placing your highest priority message first.
Message 1 of 1
5
T I M E
INS
Embedded Data...
TD 200 Embedded Data Value Place Holder in Message
Digits to the right of the
decimal
Signed
Unsigned
2
Real (floating point)
Edit Notification Bit:
Address of Data Value:
OK
10 15
E L A P S E D
Message beginning address:
Message enabled bit:
Acknowledgement notification bit:
<Previous Message Next Message >
< Prev
Finish
S7-200 Programmable Controller System Manual
C79000-G7076-C230-02
V45.2
VD47
Cancel
20
VB32
VB12.7
V45.1
Cancel