Siemens Simatic S7-200 System Manual page 33

Install/Remove Modules
Selection:
CPU5411
CPU5511 (Plug & Play)
CPU5611 (Plug & Play)
MPI-ISA on board
PC Adapter (PC/MPI-Cable)
MPI/PROFIBUS Card for PC
Close
Figure 3-1
Troubleshooting the Installation
The following situations can cause the installation to fail:
Not enough memory: at least 50 Mbytes of free space are required on your hard disk.
Bad diskette: verify that the diskette is bad, then call your salesman or distributor.
Operator error: start over and read the instructions carefully.
Failure to close any open applications, including the Microsoft Office toolbar
Review the README x .TXT file included on your diskettes for the most recent information
about STEP 7-Micro/WIN. (In the x position, the letter A = German, B = English, C = French,
D = Spanish, E = Italian.)
S7-200 Programmable Controller System Manual
C79000-G7076-C230-02
Installing and Using the STEP 7-Micro/WIN Software
Install -->
<-- Remove
Install/Remove Modules Dialog Box
Installed:
MPI-ISA Card
PC/PPI cable
This button appears
if you are using a
Resources...
Windows NT
operating system.
Help
3-3