Siemens Simatic S7-200 System Manual page 35

Note
STEP 7-Micro/WIN 16 does not support the multi-master parameter set under the
Windows 95 or Windows NT 4.0 operating system.
The following hardware configurations are possible:
CPU 212, CPU 214, CPU 216, CPU 215 (port 0)
– PC/PPI Cable (PPI), 9.6 kbaud or 19.2 kbaud
– MPI Card (PPI), 9.6 kbaud or 19.2 kbaud
CPU 215 (port 1, that is, the DP port)
MPI Card (MPI), 9.6 kbaud to 12 Mbaud
Note
STEP 7-Micro/WIN 16 does not support communications on port 1 of the CPU 215.
The selections for MPI Card are different for STEP 7-Micro/WIN 16 and
STEP 7-Micro/WIN 32.
On the left side of the Install/Remove Modules dialog box is a list of hardware types that you
have not installed yet (see Figure 3-1). On the right side is a list of currently installed
hardware types. If you are using the Windows NT 4.0 operating system, there is a
"Resources" button under the Installed list box.
To install the hardware, follow these steps:
1. From the Selection list box, select the hardware type that you have. A description of your
selection is shown in the lower window.
2. Click the "Install -->" button.
To remove hardware, follow these steps:
1. Select the hardware from the Installed list box on the right.
2. Click the "<-- Remove" button.
When you are finished installing or removing hardware, click the "Close" button. This action
returns you to the Setting the PG/PC Interface dialog box. The selections that you made
appear now in the list box that contains the module parameter sets. See Figure 3-7.
For detailed information on the communications setup for your configuration, see
Section 3.3.
S7-200 Programmable Controller System Manual
C79000-G7076-C230-02
Installing and Using the STEP 7-Micro/WIN Software
3-5