Siemens Simatic S7-200 System Manual page 452

Index
B
Bar graph character set, TD 200, 5-4
Battery cartridge, 7-11
dimensions, A-80
order number, G-3
specifications, A-80
Baud rates
communication ports, 9-2
CPUs, 9-2
PC/PPI cable, A-82
switch selections on the PC/PPI cable, 3-7,
9-10
BCD to Integer instruction, 10-108
Bias
adjustment, PID loop control, 10-61
PID algorithm, 10-57
Biasing, network, 9-7
Bit access, 7-2
CPU 212/214/215/216, 10-3
Bit memory, 7-2
addressing, 7-3
Bits, special memory, D-1–D-13
Block Move Byte instruction, 10-69
Block Move Double Word instruction, 10-69
Block Move Word instruction, 10-69
Boolean contact instructions, example, 10-6
Buffer consistency, 9-20
Bus connector, 2-5–2-7
removing expansion modules, 2-7
Bus expansion port, removing breakaway cover,
2-5–2-7
Byte, and integer range, 7-3
Byte access, 7-2
CPU 212/214/215/216, 10-3
using pointer, 7-10
Byte address format, 7-2
Byte consistency, 9-20
Byte memory, 7-2
Index-2
C
Cables
I/O expansion cable, specifications, A-81
installing the expansion cable, 2-5–2-7
MPI, 3-8
order number, G-2
PC/PPI, 9-9–9-11
baud rates, A-82
pin assignment, A-82
setting parameters, 3-12
specifications, A-82
PROFIBUS network, 9-8
removing modules, 2-7
Calculating power requirements, 2-15
Calibration
EM231, A-61
EM235, A-70, A-72
Call instruction, 10-88
CE certification, A-3
Changing a pointer, 7-10
Character interrupt control, 10-129
Characters, TD 200 Wizard, 5-9
Clearance requirements, 2-2
Clock
enabling, 5-4
status bits, D-1
Clock instructions, 10-13
Clock, Real-Time, 10-49
Communication instructions, 10-124–10-136
Network Read, 10-133
Network Write, 10-133
Receive, 10-124
Transmit, 10-124
Communication port
interrupts, 10-118
pin assignment, 9-6
S7-200 Programmable Controller System Manual
C79000-G7076-C230-02