Analog Trunk Data Setup - NEC SL 1000 Programming Manual

ISSUE 1.0
Level
IN
Description
Use Program 14-02 : Analog Trunk Data Setup to set the basic options for each analog trunk port.
Refer to the table below for a description of each option, its range and default setting.
Input Data
Item
No.
01
02
03
04
05
06
Programming Manual
Downloaded from www.Manualslib.com
Program 14 : Trunk, Basic Setup
Trunk Port Number
Item
Signaling Type (DP/DTMF) 0 = Dial Pulse (10 PPS)
This option sets the signaling 2 = DTMF
type for the trunk.
Ring Detect Type 0 = Normal/delayed
This option sets Extended Ring 1 = Immediate Ringing
Detect or Immediate Ring De-
tect for the trunk. For T1 loop/
ground start trunks, this option
must be set to 1 for the trunks
to ring and light correctly.
Flash Type 0 = Open Loop Flash
This option selects the flash 1 = Ground
type (open loop flash or
ground). Always set this option
for open loop flash.
Hooking Type 0 = Timed Flash (Hooking)
This option lets you use Flash 1 = Disconnect (Cut)
for Timed Flash (Program 81-
01-14) or Disconnect (Program
81-01-15). (A user implements
Flash by pressing the FLASH
key while on a trunk call.)
Dial Tone Detection for Manu- 0 = Dial Tone Detection
ally Accessed Trunks Not Used
Use this option enable/disable 1 = Dial Tone Detection
dial tone detection for directly Used
accessed trunks. If disabled,
the system outdials on the
trunks without monitoring for
dial tone.
Pause at 1st Digit after Line 0 = No Pause (No)
Seize in Manual Dial Mode 1 = Pause (Yes)
manuals search engine

14-02 : Analog Trunk Data Setup

001 ~ 126 (SL1000)
001 ~ 096 (SL1100)
Input Data Default
2
0
0
1 (SL1000)
0 (SL1100)
1
1
SL1000/SL1100
Related Pro-
Note
gram
81-01-14
81-01-15
21-01-04
21-01-06
2-101
Program
14