NEC SL 1000 Programming Manual page 362

SL1000/SL1100
Item
No.
04
Program
34
05
06
07
08
2-340
Downloaded from www.Manualslib.com
Item
Route Table Setup of Target 0 = SPD Table
Dial (Program 13-03)
The option sets how the system 1 = DID Table
uses the route data (gathered (Program 22-11)
in Item 3) to route incoming
ANI/DNIS calls.
If option 2 is selected, and the
call is to be routed using the
DID table (1), up to eight digits
can be matched. The number
of expected digits set in Pro-
gram 22-09-01 must match the
ANI digits defined in Program
22-11-01. For example, if an
ANI/ DNIS number received
was
2035551234 3001 and
* * *
Program 22-09- 01 = 4, the
entry in 22-11-01 must be 1234
with the defined target exten-
sion.
If the call is to be routed using
the ABB table (0), up to 36 dig-
its can be matched. Define the
range of the ABB table to be
used in Program 34-09-06. The
data is compared to the entries
in Program 13-04-01 and then
routed according to Program
13-04-03.
ANI/DNIS Display as Target 0 = Display Off
Dial Name 1 = Display On
Use this option to set whether
or not ANI data should appear
on telephone displays as part
of Caller ID display.
Routing SPD Table Setup Start = 0, 100 ~ 900
Use this option to define which End = 0, 99 ~ 999
part of the ABB Table set up in
Program 13-04 the system
uses for ANI/DNIS Caller ID
look-ups and ANI/DNIS routing.
This is required if Items 4 and 5
above are 1 (Caller ID on).
When you specify a starting
and end address, the system
uses the part of the table for
look-ups.
When you specify a starting
address and length, the system
uses that part of the table for
routing. If the incoming ANI/
DNIS number data matches the
Number entry in the table, the
system routes according to the
associated Name data. That
data can be an extension, De-
partment Group pilot number,
the voice mail master number
or a trunk ring group.
Routing on ANI/DNIS Error 0 = Play Busy Tone to
This option lets you determine Caller
how the system handles an 1 = Route Caller to Ring
ANI/DNIS call if a data error is Group Specified in Pro-
detected in the incoming data gram 25-03 (Transfer)
string.
Routing When Destination 0 = Play Busy or Ringback
Busy or No Answer Tone to Caller (Busy/
This option lets you determine NoAns)
how the system handles an 1 = Route Caller to Ring
ANI/DNIS call if destination is Group Specified in Pro-
busy or does not answer. gram 25-04 (Transfer)
manuals search engine
Default
Input Data
COS 01
0
1
Start = 900
End = 999
1
0
ISSUE 1.0
Default
Related
Program
COS 02 ~ 15
0 13-04
22-11-03
34-09-05
0 13-04
20-09-02
22-11-03
23-09-04
Start = 0 13-04
End = 0
0 25-03
0 25-04
Program 34 : Tie Line Setup