Setup Wizard Step 9 Of 10: Signatures & Engine - NETGEAR UTM5 Reference Manual

ProSecure Unified Threat Management (UTM) Appliance
Setup Wizard Step 9 of 10: Signatures & Engine
Figure 33.
Enter the settings as explained in the following table, and then click Next to go the following
screen.
Table 12. Setup Wizard Step 9: Signatures & Engine screen settings
Setting
Update Settings
Update
Update From
Using the Setup Wizard to Provision the UTM in Your Network
Description
From the drop-down list, select one of the following options:
• Never. The pattern and firmware files are never automatically updated.
• Scan engine and Signatures. The pattern and firmware files are
automatically updated according to the settings in the Update Frequency
section onscreen (see explanations later in this table).
Set the update source server by selecting one of the following radio buttons:
• Default update server. Files are updated from the default NETGEAR update
server.
• Server address. Files are updated from the server that you specify. Enter the
IP address or host name of the update server in the Server address field.
59