Manage The Configuration File - NETGEAR UTM5 Reference Manual

ProSecure Unified Threat Management (UTM) Appliance
Table 103. SNMP screen settings
Setting Description
Settings
Do You Want to Select one of the following radio buttons:
Enable SNMP?
•
•
Read Community
Set Community
Contact
Location
Enable Access Select the Enable Access From WAN check box to allow SNMP management over a
From WAN WAN connection. This check box is cleared by default, allowing SNMP management
only over a LAN connection.
Trusted SNMP Hosts
Enter the IP addresses of the computers and devices to which you want to grant read-only (GET) or write
(SET) privileges on the UTM. Separate IP addresses by a comma. To allow any trusted SNMP host access,
leave the field blank, which is the default setting.
SNMP Traps
Enter the IP addresses of the SNMP management stations that are allowed to receive the UTM's SNMP
traps. Separate IP addresses by a comma. If you leave the field blank, which is the default setting, no
SNMP management station can receive the UTM's SNMP traps.
3. Click Apply to save your settings.

Manage the Configuration File

The configuration settings of the UTM are stored in a configuration file on the UTM. This file
can be saved (backed up) to a PC, retrieved (restored) from the PC, or cleared to factory
default settings.
Once the UTM is installed and works correctly, make a backup of the configuration file to a
computer. If necessary, you can later restore the UTM settings from this file.
The Backup & Restore Settings screen lets you:
• Back up and save a copy of the current settings
• Restore saved settings from the backed-up file
• Revert to the factory default settings
Yes. Enable SNMP.
No. Disable SNMP. This is the default setting.
The community string to allow an SNMP manager access to the
MIB objects of the UTM for the purpose of reading only. The default
setting is public.
The community string to allow an SNMP manager access to the
MIB objects of the UTM for the purpose of reading and writing. The
default setting is private.
The SNMP system contact information that is available to the
SNMP manager. This setting is optional.
The physical location of the UTM. This setting is optional.
Network and System Management
418