NETGEAR UTM5 Reference Manual page 314


To enable the PPTP server and configure the PPTP server pool, authentication, and
encryption:
1. Select VPN > PPTP Server. The PPTP Server screen displays:
Figure 191.
2. Enter the settings as explained in the following table:
Table 79. PPTP Server screen settings
Setting
PPTP Server
Enable PPTP Server
ProSecure Unified Threat Management (UTM) Appliance
Description
To enable the PPTP server, select the Enable check box. Complete the
following fields:
Start IP Address
End IP Address
User time out
Virtual Private Networking Using IPSec Connections
Type the first IP address of the address pool.
Type the last IP address of the address pool. A maximum of
six contiguous addresses can be part of the pool. (The first
address of the pool cannot be assigned to a user.)
Enter the time-out period in seconds, from 300 to 1800
seconds. If there is no traffic from a user, the connection is
disconnected after the specified period.
314