Additional Wan-Related Configuration Tasks - NETGEAR UTM5 Reference Manual

ProSecure Unified Threat Management (UTM) Appliance
Table 20. Advanced WAN settings (continued)
Setting
Upload/Download Settings
These settings rate-limit the traffic that is being forwarded by the UTM.
WAN Connection Type
WAN Connection Speed
Upload
WAN Connection Speed
Download
5. Click Apply to save your changes.
WARNING:
Depending on the changes that you made, when you click Apply,
the UTM restarts, or services such as HTTP and SMTP might
restart.
If you want to configure the advanced settings for an additional WAN interface, select another
WAN interface and repeat these steps.

Additional WAN-Related Configuration Tasks

• If you want the ability to manage the UTM remotely, enable remote management (see
Configure Remote Management Access
management, NETGEAR strongly recommend that you change your password (see
Change Passwords and Administrator and Guest Settings
• You can set up the traffic meter for each WAN, if you wish. See
Meter on page 434.
Description
From the drop-down list, select the type of connection that the UTM uses to
connect to the Internet: DSL, ADLS, Cable Modem, T1, T3, or Other.
From the drop-down list, select the maximum upload speed that is provided by
your ISP. You can select from 56 Kbps to 1 Gbps, or you can select Custom
and enter the speed in Kbps in the field below the drop-down list.
From the drop-down list, select the maximum download speed that is provided
by your ISP. You can select from 56 Kbps to 1 Gbps, or you can select Custom
and enter the speed in Kbps in the field below the drop-down list.
Manually Configuring Internet and WAN Settings
91
on page 415). If you enable remote
on page 413).
Enable the WAN Traffic