NETGEAR UTM5 Reference Manual page 437

ProSecure Unified Threat Management (UTM) Appliance
Table 108. WAN traffic meter settings (continued)
Setting
When Limit is reached
Block Traffic
Send e-mail alert
3. Click Apply to save your settings.
4. For the multiple WAN port models only, click the WAN2 Traffic Meter, WAN3 Traffic Meter
(UTM150 only), or WAN4 Traffic Meter (UTM150 only) submenu tab to display the
corresponding WAN Traffic Meter screen. These screens are identical to the WAN1 Traffic
Meter screen (see
5. For the multiple WAN port models only, repeat
interface or interfaces.
To display a report of the Internet traffic by type, click the Traffic by Protocol option arrow in
the upper right of the WAN Traffic Meter screen (single WAN port models) or in the upper
right of one of the WAN Traffic Meter screens (multiple WAN port models). The Traffic by
Protocol screen displays in a pop-up screen. The incoming and outgoing volume of traffic for
each protocol and the total volume of traffic are displayed. Traffic counters are updated in
MBs; the counter starts only when traffic passed is at least 1 MB. In addition, the pop-up
screen displays the traffic meter's start and end dates.
Figure 261.
Description
Select one of the following radio buttons to specify which action the UTM performs
when the traffic limit has been reached:
• Block All Traffic. All incoming and outgoing Internet and email traffic is
blocked.
• Block All Traffic Except E-Mail. All incoming and outgoing Internet traffic is
blocked, but incoming and outgoing email traffic is still allowed.
An email alert is sent when traffic is blocked. Ensure that emailing of logs is enabled
on the Email and Syslog screen (see
Syslog Logs on page 439).
Figure 260 on page 435).
Monitoring System Access and Performance
437
Configure and Activate System, Email, and
Step 2 and Step 3 for the additional WAN