Rear Panel Utm50 And Utm150; Rear Panel Utm9S - NETGEAR UTM5 Reference Manual

ProSecure Unified Threat Management (UTM) Appliance

Rear Panel UTM50 and UTM150

The rear panel of the UTM includes a cable lock receptacle, a console port, a factory default
Reset button, and an AC power connection.
Console port
Factory Defaults
reset button
Figure 10. Rear panel of the UTM50 and UTM150
Viewed from left to right, the rear panel of the UTM50 and UTM150 contains the following
components:
1. Console port. Port for connecting to an optional console terminal. The port has a DB9
male connector. The default baud rate is 9600 K. The pinouts are (2) Tx, (3) Rx, (5) and
(7) Gnd.
2. Factory default Reset button. Using a sharp object, press and hold this button for about
8 seconds until the front panel Test LED flashes to reset the UTM to factory default settings.
Configuration changes are lost, and the default password is restored.
3. Cable security lock receptacle.
4. AC power receptacle. Universal AC input (100–240 VAC, 50–60 Hz).

Rear Panel UTM9S

Security lock
receptacle
Factory Defaults
reset button
Console switch
Console port
Figure 11. Rear panel of the UTM9S
Viewed from left to right, the rear panel of the UTM9S contains the following components:
1. Cable security lock receptacle.
Security lock
receptacle
Introduction
32
AC power
receptacle
AC power
receptacle
Power
switch