NETGEAR UTM5 Reference Manual page 558


To configure the wireless access point:
1. Select Network Config > Wireless Settings > Access Point. The Access Point screen
displays. (The following figure shows some examples.)
Figure 326.
The following table explains the fields of the Access Point screen:
Table 146. Access Point screen settings
Item
Status
Virtual AP
SSID
Broadcast
Profile Name
VLAN
Active Time
Start Time
Stop Time
2. Click the Edit table button in the Action column. The Edit Access Point screen displays:
ProSecure Unified Threat Management (UTM) Appliance
Description
The status of the access point (Enabled or Disabled).
The name for the virtual access point (VAP) is ap1. You cannot change this
name.
The wireless network name (SSID) for the security profile that is allocated to the
access point.
Indicates whether or not the SSID is broadcast. A green circle indicates that the
SSID is broadcast; a gray circle indicates that it is not.
The security profile that is allocated to the access point.
The VLAN to which the access point is allocated.
Indicates whether or not the timer for the access point is activated (No or Yes).
The start time for the timer.
The stop time for the timer.
Wireless Module for the UTM9S
558