NETGEAR UTM5 Reference Manual page 419

To display the Backup & Restore Settings screen, select Administration > Backup &
Restore Settings.
Figure 252.
Back Up Settings
The backup feature saves all UTM settings to a file. These settings include:
• Network settings. IP address, subnet mask, gateway, and so on.
• Scan settings. Services to scan, primary and secondary actions, and so on.
• Update settings. Update source, update frequency, and so on.
• Antispam settings. Whitelist, blacklist, content-filtering settings, and so on.
Back up your UTM settings periodically, and store the backup file in a safe place.
Tip: You can use a backup file to export all settings to another UTM that has
the same language and management software versions. Remember to
change the IP address of the second UTM before deploying it to
eliminate IP address conflicts on the network.

To back up settings:
1. On the Backup & Restore Settings screen (see the previous figure), next to Save a copy
of current settings, click the Backup button to save a copy of your current settings. A
screen displays, showing the file name of the backup file (backup.pkg).
2. Select Save file, and then click OK.
3. Open the folder in which you have saved the backup file, and then verify that it has been
saved successfully.
Note the following:
• If your browser is not configured to save downloaded files automatically, locate the folder
in which you want to save the file, specify the file name, and save the file.
• If your browser is configured to save downloaded files automatically, the file is saved to
your browser's download location on the hard disk.
ProSecure Unified Threat Management (UTM) Appliance
Network and System Management
419