Ssl Vpn Wizard Step 4 Of 6 (Client Addresses And Routes) - NETGEAR UTM5 Reference Manual

Prosecure unified threat management appliance

Hide thumbs Also See for UTM5:

Table of Contents

ProSecure Unified Threat Management (UTM) Appliance

SSL VPN Wizard Step 4 of 6 (Client Addresses and Routes)

Note that the previous figure contains an example. Enter the settings as explained in the

following table, and then click Next to go the following screen.

Do not enter an existing route for a VPN tunnel client in the

Destination Network and Subnet Mask fields; otherwise, the SSL

VPN Wizard will fail and the UTM will reboot to recover its

configuration.

Table 86. SSL VPN Wizard Step 4 of 6 screen settings (client addresses and routes)

Client IP Address Range

Enable Full Tunnel Support

Virtual Private Networking Using SSL Connections

Select this check box to enable full-tunnel support. If you leave this check box

cleared (which is the default setting), full-tunnel support is disabled but

split-tunnel support is enabled, and you need to add a client route by completing

the Destination Network and Subnet Mask fields.

When full-tunnel support is enabled, client routes are not operable.

A DNS suffix to be appended to incomplete DNS search strings. This setting is

Utm9s Utm10 Utm150 Utm25 Utm50