Configure Custom Groups - NETGEAR UTM5 Reference Manual

Configure Custom Groups

After you have specified groups and users (see
and Users on page 358), you can create up to 200 custom groups, each of which can include
a combination of local groups and local users, groups and users that are defined by their IP
addresses, LDAP groups and users, and RADIUS groups and users. You use these custom
groups when you define firewall rules (see
Traffic on page 121) or when you set web access exceptions (see
Web and Application Access
Note: You can assign custom groups to all types of firewall rules with the
exception of DMZ WAN outbound rules and LAN DMZ inbound rules.

To create and manage custom groups:
1. Select Users > Custom Groups. The Custom Groups screen displays. This screen
shows the Custom Groups table, which is empty if you have not specified any custom
groups. (The following figure shows one custom group in the table as an example.)
Figure 226.
2. Under the Custom Groups table, click the Add table button to specify a custom group. The
Add Custom Group screen displays:
ProSecure Unified Threat Management (UTM) Appliance
on page 234).
Managing Users, Authentication, and VPN Certificates
Configure Authentication Domains, Groups,
Use Rules to Block or Allow Specific Kinds of
375
Set Exception Rules for