Configure The Pptp Server - NETGEAR UTM5 Reference Manual

Prosecure unified threat management appliance

Hide thumbs Also See for UTM5:

Table of Contents

Select the Enable NetBIOS check box.

Click Apply to save your settings.

Configure the PPTP Server

As an alternate solution to IPSec VPN and L2TP tunnels, you can configure a Point-to-Point

Tunnel Protocol (PPTP) server on the UTM to allow users to access PPTP clients over PPTP

tunnels. A maximum of five simultaneous PPTP user sessions are supported. (The very first

IP address of the PPTP address pool is used for distribution to the UTM.)

A PPTP user typically initiates a tunnel request; the PPTP server accommodates the tunnel

request and assigns an IP address to the user. After a PPTP tunnel is established, the user

can connect to a PPTP client that is located behind the UTM.

You need to enable the PPTP server on the UTM, specify a PPTP server address pool, and

create PPTP user accounts. For information about how to create PPTP user accounts, see

Configure User Accounts

ProSecure Unified Threat Management (UTM) Appliance

on page 378.

Virtual Private Networking Using IPSec Connections

Utm9s Utm10 Utm150 Utm25 Utm50