NETGEAR UTM5 Reference Manual page 467

ProSecure Unified Threat Management (UTM) Appliance
Table 121. Detailed Status screen fields (continued)
Item Description
IP Address The IP address of the WAN port.
Subnet Mask The subnet mask of the WAN port.
Gateway The IP address of the gateway.
Primary DNS Server The IP address of the primary DNS server.
Secondary DNS Server The IP address of the secondary DNS server.
MAC Address The default MAC address for the port or the MAC address that you have specified on
the WAN Advanced Options screen for the port. For information about configuring the
MAC address, see
Wireless information in SLOT-1 Info or SLOT-2 Info
Note: For the UTM9S only: Wireless information is shown in the SLOT-1 Info or SLOT-2 Info section, depending
on the slot in which the wireless module is installed.
The following fields are shown for the wireless module:
Card Type This is a fixed field that states Wireless.
Daughter Card This is a fixed field that states Wireless.
Firmware Version This is a fixed field that states N/A. This field might show a software version in a future
release.
SSID The SSID of the wireless access point that you have specified on the Edit Profile
screen. For information about configuring the SSID, see
Wireless Security Profiles
Security Type The type of wireless security and encryption that you have specified on the Edit Profile
screen. For information about configuring wireless security, see
Options
Country The region and country that you have specified
on the Radio Settings screen.
Operating Frequency The operating frequency that you have
specified on the Radio Settings screen:
2.4 GHz or 5 GHz.
Advanced Wireless The wireless mode that you have specified on
Network Mode the Radio Settings screen.
Channel The channel or automatic channel selection
that you have specified on the Radio Settings
screen.
IP Address The IP address of the default WLAN that is specified on the LAN Setup screen. For
information about how to change the default WLAN IP address, see
Profile
MAC Address The MAC address for the wireless access point is a fixed address that is assigned to
the wireless module.
Configure Advanced WAN Options
on page 553.
on page 549 and Wireless Security Profile
on page 96.
Monitoring System Access and Performance
467
These settings are either obtained
dynamically from your ISP or
specified by you on the WAN ISP
Settings screen for this port (see
Manually Configure the Internet
Connection on page 70).
on page 89.
Configure and Enable
Wireless Data Security
on page 551.
For information about configuring the
basic wireless radio settings, see
Configure the Basic Radio Settings
page 546.
Configure a VLAN
on