How To Send Syslogs Over A Vpn Tunnel Between Sites - NETGEAR UTM5 Reference Manual

3. Click Apply to save your settings, or click Clear Log Information to clear the selected logs.

How to Send Syslogs over a VPN Tunnel between Sites


To send syslogs from one site to another over a gateway-to-gateway VPN tunnel:
1. At Site 1, set up a syslog server that is connected to Gateway 1.
2. Set up a VPN tunnel between Gateway 1 at Site 1 and Gateway 2 at Site 2.
3. Change the remote IP address in the VPN policy on Gateway 1 to the WAN IP address of
Gateway 2.
4. Change the local IP address in the VPN policy on Gateway 2 to the WAN IP address of
Gateway 2.
5. At Site 2, specify that Gateway 2 should send the syslogs to the syslog server at Site 1.
This section describes steps 2 through 4, using the topology that is described in the following
table:
Type of address
WAN IP address
LAN IP address
LAN subnet mask
LAN IP address syslog server
Configure Gateway 1 at Site 1

To create a gateway-to-gateway VPN tunnel to Gateway 2, using the IPSec VPN wizard:
1. Select VPN > IPSec VPN > VPN Wizard. The VPN Wizard screen displays.
2. Configure a gateway-to-gateway VPN tunnel using the following information:
• Connection name. Any name of your choice
• Pre-shared key. Any key of your choice
• Remote WAN IP address. 10.0.0.2
• Local WAN IP address. 10.0.0.1
• Remote LAN IP Address. 192.168.20.0
• Remote LAN subnet mask. 255.255.255.0
3. Click Apply to save the settings.

To change the remote IP address in the VPN policy:
1. Select VPN > IPSec VPN > VPN Policies. The VPN Policy screen displays.
2. Next to the policy name for the Gateway 1–to–Gateway 2 autopolicy, click Edit. The Edit
VPN Policy screen displays.
ProSecure Unified Threat Management (UTM) Appliance
Gateway 1 at Site 1 Gateway 2 at Site 2
10.0.0.1
192.168.10.0
255.255.255.0
192.168.10.2
Monitoring System Access and Performance
10.0.0.2
192.168.20.0
255.255.255.0
not applicable
443