Configuring Initial Position - HIKVISION PanoVu Mini Series User Manual

User Manual of Network PTZ Camera
2. Click Enable Limit and choose the limit type.

Manual Stops:
When manual limit stops are set, you can operate the PTZ control panel manually only
in the limited surveillance area.
3. Click the PTZ control buttons to find the left/right/up/down limit stops; you can also call the
defined presets and set them as the limits of the camera.
4. Click Set to save the limits or click Clear to clear the limits.
5. Click

5.4.3 Configuring Initial Position

Purpose:
The initial position is the origin of PTZ coordinates. It can be the factory default initial position.
You can also customize the initial position according to your own demand.
 Customize an Initial Position:
Steps:
1. Enter Initial Position configuration interface:
Configuration > PTZ > Initial Position
© Hikvision
Figure 5-23 Configure the PTZ Limit
to save the settings.
49