Configuring Video Tampering Alarm - HIKVISION PanoVu Mini Series User Manual

User Manual of Network PTZ Camera
 Child directory: It is a sub-folder which can be created in the parent directory. The files
will be saved in a sub-folder in FTP server. The name of folder can be defined as shown
in Figure 6-10.
 Upload type: To enable uploading the captured picture to the FTP server.
3. Click Save to save the settings.
4. You can click Test to confirm the configuration.
If you want to upload the captured pictures to FTP server, you also have to enable the
continuous snapshot or event-triggered snapshot in Snapshot interface.
Configuring Email Settings to set the Email parameters.
•
Upload to FTP/Memory Card/NAS: Capture the image when an alarm is triggered and
upload the picture to a FTP server.
Note: You need a FTP server and set FTP parameters first. Refer to Section FTP for
setting FTP parameters.
•
Trigger Recording: Record a video when an event occurs.
Note:
You have to set the recording schedule to realize this function. Refer to Section 5.1.1
Configuring Recording Schedule for settings the recording schedule.
•
PTZ Linking:
Target Linkage: The PT camera channel moves to capture the detected motion and
upload captured picture to surveillance center. Response Time here means the time
interval between two linkage actions. You can specify the Response Time to avoid too
frequent camera movement.

5.2.2 Configuring Video Tampering Alarm

Purpose:
You can configure the camera to trigger the alarm actions when the lens is covered.
Steps:
1. Enter Video Tampering settings interface :
Configuration > Event > Basic Event > Video Tampering
© Hikvision
Figure 5-12 Parent Directory
Figure 5-13 Child Directory
37