Configuring Alarm Input - HIKVISION PanoVu Mini Series User Manual

User Manual of Network PTZ Camera

5.2.3 Configuring Alarm Input

Note:
This function varies depending on different camera models.
Steps:
1. Enter the Alarm Input settings interface:
Configuration > Event > Basic Event > Alarm Input
2. Choose the Alarm Input No. and the Alarm Type. The alarm type can be NO (Normally Open)
and NC (Normally Closed).
3. Edit the name in
alarm input (optional).
4. Click
schedule configuration is the same as the setting of the arming schedule for motion detection.
Refer to Section 5.2.1 Configuring Motion Detection.
5. Click
surveillance center, and send email are selectable. Refer to Section 5.2.1 Configuring Motion
Detection.
6. You can also choose the PTZ linking for the alarm input. Check the relative checkbox and
select the No. to enable Preset Calling, Patrol Calling or Pattern Calling.
7. You can copy your settings to other alarm inputs.
8. Click
© Hikvision
Figure 5-15 Alarm Input Settings
tab to enter the arming schedule setting interface. The arming
tab to select the linkage method taken for tampering, notify
to save the settings.
39
to set a name for the