Configuring Qos Settings - HIKVISION PanoVu Mini Series User Manual

User Manual of Network PTZ Camera
 When the port number is not the default number 443, the format of the URL is https://IP
address:port number, eg., https://192.168.1.64:81.

Configuring QoS Settings

Purpose:
QoS (Quality of Service) can help solve the network delay and network congestion by configuring
the priority of data sending.
Steps:
1. Enter QoS settings interface:
Configuration >Advanced Configuration > Network > QoS
2. Configure the QoS settings, including video/audio DSCP, event/alarm DSCP and Management
DSCP.
The valid DSCP value ranges from 0 to 63. The DSCP value is bigger, the priority is higher.
3. Click
 Make sure that you enable the QoS function of your network device (such as a router).
 It will ask for a reboot for the settings to take effect.
Configuring 802.1X Settings
Purpose:
The camera supports IEEE 802.1X standard.
IEEE 802.1X is a port-based network access control. It enhances the security level of the LAN.
When devices connect to this network with IEEE 802.1X standard, the authentication is needed. If
the authentication fails, the devices don't connect to the network.
The protected LAN with 802.1X standard is shown in Figure 6-16.
© Hikvision
Figure 6-15 QoS Settings
to save the settings.
67