User Manual of Network PTZ Camera
5.2 Basic Event Configuration
Purpose:
This section explains how to configure the network camera to respond to alarm events, including
motion detection, video tampering, and exception. These events can trigger the alarm actions,
such as Send Email, Notify Surveillance Center, etc.
For example, when motion detection is triggered, the network camera sends a notification to an
e-mail address.
On the event configuration page, click
Click the direction buttons to control the pan/tilt movements.
Click the zoom/iris/focus buttons to realize lens control.
The functions vary depending on different camera models.
5.2.1 Configuring Motion Detection
Purpose:
Motion detection is a feature which can trigger alarm actions and actions of recording videos
when the motion occurred in the surveillance scene.
Steps:
1.
Enter the Motion Detection settings interface:
Configuration > Event > Basic Event > Motion Detection
2.
Select the Channel No. from the dropdown list.
3.
Set the Motion Detection Area.
i.
Check the Enable Motion Detection checkbox.
ii.
Check the Enable Dynamic Analysis for Motion checkbox.
4.
Select the configuration mode as Normal or Expert and set the corresponding motion detection
parameters.
Normal:
© Hikvision
to show the PTZ control panel or click
33
to hide it.