HIKVISION PanoVu Mini Series User Manual page 72

User Manual of Network PTZ Camera
Sender: The name of the email sender.
Sender's Address: The email address of the sender.
SMTP Server: The SMTP Server IP address or host name (e.g., smtp.263xmail.com).
SMTP Port: The SMTP port. The default TCP/IP port for SMTP is 25.
E-mail encryption: None, SSL, and TLS are selectable. When you select SSL or TLS and disable
STARTTLS, e-mails will be sent after encrypted by SSL or TLS. The SMTP port should be set as
465 for this encryption method. When you select SSL or TLS and enable STARTTLS, emails will
be sent after encrypted by STARTTLS, and the SMTP port should be set as 25.
STARTTLS protocol must be supported by the email server for e-mail encryption with
STARTTLS. When it is not supported by the email server and Enable STARTTLS is checked, the
email will not be encrypted.
Attached Image: Check Attached Image if you want to send emails with attached alarm
images.
Attached Image function is invalid when sub-stream is enabled.
Authentication (optional): If your email server requires authentication, check this checkbox to
use authentication to log in to this server and enter the login user name and password.

For your privacy and to better protect your system against security risks, we strongly
recommend the use of strong passwords for all functions and network devices. The
password should be something of your own choosing (using a minimum of 8 characters,
including upper case letters, lower case letters, numbers and special characters) in order
to increase the security of your product.

Proper configuration of all passwords and other security settings is the responsibility of
the installer and/or end-user.
Receiver: Select the receiver to which the email is sent. Up to 2 receivers can be configured.
Receiver: The name of the user to be notified.
Receiver's Address: The email address of user to be notified. (Optional: click Test to make sure
that the email server can send email out.)
3. Click
Configuring Platform Settings
Purpose:
Platform access provides you an option to manage the devices via platform.
Steps:
1. Enter Platform settings interface:
Configuration> Network > Advanced Settings > Platform Access
2. Check the checkbox of Enable to enable the platform access function of the device.
© Hikvision
to save the settings.
64