HIKVISION PanoVu Mini Series User Manual page 36

User Manual of Network PTZ Camera

Pre-record: The time you set to start recording before the scheduled time or the event.
For example, if an alarm triggers recording at 10:00, and the pre-record time is set as 5
seconds, the camera starts to record at 9:59:55.
The pre-record time can be configured as No Pre-record, 5 s, 10 s, 15 s, 20 s, 25 s, 30 s or
not limited.
The pre-record time changes according to the video bitrate.

Post-record: The time you set to stop recording after the scheduled time or the event.
For example, if an alarm triggered recording ends at 11:00, and the post-record time is
set as 5 seconds, the camera records until 11:00:05.
The Post-record time can be configured as 5 s, 10 s, 30 s, 1 min, 2 min, 5 min or 10 min.

Stream Type: You can select the stream type for recording.
The Pre-record and Post-record parameters vary depending on different camera models.
5. Click OK to save the advanced setting.
6. Select a Record Type. The record type can be Continuous, Motion, Motion | Alarm, and
Event.

Normal: If you select Continuous, the video will be recorded automatically according to
the time of the schedule.

Record Triggered by Motion Detection: If you select Motion, the video will be recorded
when the motion is detected. Besides configuring the recording schedule, you have to
set the motion detection area and check Trigger Channel in the Linkage Method of
Motion Detection settings interface. For detailed information, refer to Section Motion
Detection.

Record Triggered by Motion | Alarm: If you select Motion | Alarm, the video will be
recorded when the external alarm is triggered or the motion is detected. Besides
configuring the recording schedule, you have to configure the settings on the Motion
Detection settings interfaces.

Record Triggered by Event: If you select to record by event, the video will be recorded
when any of the events is triggered.
7. Click
© Hikvision
Figure 5-2 Record Parameters
to save the settings.
28