HIKVISION PanoVu Mini Series User Manual page 46

User Manual of Network PTZ Camera
2. Select the camera channel to configure.
3. Check Enable to enable the tampering detection.
4. Click Draw Area. Drag the mouse on the live view image to draw a motion detection area.
5. Click Stop Drawing to finish drawing or click Clear All to clear all of the areas you set without
saving them.
6. Sensitivity: Move the slider to set the sensitivity of alarm action. The levels of sensitivity can
be set as Low, Medium, and High. The higher the value is, the easier the alarm will be
triggered.
7. Click
schedule configuration is the same as the setting of the arming schedule for motion detection.
Refer to Section 5.2.1 Configuring Motion Detection.
8. Click
surveillance center, and send email are selectable. Refer to Section 5.2.1 Configuring Motion
Detection.
9. Click
© Hikvision
Figure 5-14 Tampering Alarm
tab to enter the arming schedule setting interface. The arming
tab to select the linkage method taken for tampering, notify
to save the settings.
38