HIKVISION PanoVu Mini Series User Manual page 43

User Manual of Network PTZ Camera
i. Set the Scheduled Image Settings switch mode, there are OFF, Auto-Switch and
Scheduled-Switch selectable. If the Scheduled Image Settings switch mode is
enabled, you can configure the detection rule for the day and night separately.
•
OFF: Disable the day and night switch.
•
Auto-Switch: Switch the day and night mode according to the illumination
automatically.
•
Scheduled-Switch: Switch to the day mode at 6:00 a.m., and switch to the night
mode at 18:00 p.m.
ii. Select Area No. to configure in the dropdown list.
iii.
Set the values of sensitivity.
• Sensitivity: The greater the value is, the easier the alarm will be triggered.
5.
Set the Arming Schedule for Motion Detection.
i. Choose the day you want to set the arming schedule.
ii. Click Save to set the time period for the arming schedule.
iii. After you set the arming schedule, you can click Copy to copy the schedule to other
days (Optional).
iv. Click Save to save the settings.
Note:
The time of each period cannot be overlapped.
6.
Set the Linkage Method for Motion Detection.
Motion detection is a feature which can trigger alarm actions and actions of recording
videos when the motion occurred in the surveillance scene.
Check the checkbox to select the linkage method. Supported linkage types may vary
according to different camera models.
•
Notify Surveillance Center: Send an exception or alarm signal to remote management
software when an event occurs.
•
Send Email: Send an email with alarm information to a user or users when an event
occurs.
© Hikvision
Figure 5-10 Motion Detection Settings-Expert
35