How To Record A Session; How To Playback A Session - Agilent Technologies FieldFox N9912A User Manual

 When GPS is enabled and displayed, the current location and elevation are
NOTE If Recording or Playback is not occurring when you think it should, check the
following:
 Is the sweep in
 Is Recording or Playback
 Is the Record or Playback Interval set to a long delay? (Configuration settings.)

How to Record a Session

 Press Trace 6
 Then
 Optionally set resolution (points). Learn how on page 78. This can NOT be
 Then either:
 Then
 Then
REC
During recording, choose from the following:




How to Playback a Session

 Press Trace 6
 If the session is already open, skip the following step. Otherwise:
 Then
 Then
 Then
PLAY
of the recording is reached, playback begins again at trace 1 and continues to
loop indefinitely.
Interference Analyzer (SA Mode) Option 236
annotated at the bottom of the playback display. Learn more about GPS on
page 148.
? (upper-left annotation)
HOLD
Record Playback Setup
changed after a session is opened.
OR
New Session
o
then
Recall Session
o
Recorder Player
Record
is displayed in the left of screen graticules.
Temporarily halts recording until pressed again. The
Pause Resume
incoming trace continues to sweep. Press again to continue recording.
Stop Immediately stops recording. Then choose from the following:
Press to start replaying the recording from the beginning.
Play
o
Press to continue recording.
Record
o
Press to insert a User Tag at the current recorded trace. This allows
User Tag
you to quickly move to this location during playback. Learn more in About
State and User Tags on page 100.
Record Playback Setup
Press
Recall Session
o
Recorder Player
Play
is displayed in the left of screen graticules during playback. When the end
Paused ? (mid-left annotation)
and select a session.
Open
Then select a session to playback and press Open.
101