Agilent Technologies FieldFox N9912A User Manual page 68

How to use the Antenna/Cable Editor
 Press
 Then
 Then use the ▲|▼ arrows to select a field,
 Optionally choose from the following:
When the table edits are complete
 Press
 Press
 Press

About the Antenna/Cable header fields
 Description: Enter a description for the antenna or cable correction table. This
 Antenna Unit: Units in which the measurement will be displayed. Select
 Freq Interpolation: Set to LINear and can NOT be edited.
68
then to clear all data from the existing Antenna or Cable table
New Yes
and reset header information to default settings.
or
Edit Antenna
When editing Header information, press
o
using the FieldFox labeler.
When editing Frequency/Value pairs, enter numbers using the numeric
o
keypad, and a frequency suffix when necessary. Then Enter. Positive Values
are interpreted as LOSS for both Cable Loss and Antenna Gain Factor.
Learn more about "How the Freq/Value pairs are applied" below.
Previous / Next Page
o
Add a blank Freq/Value pair to the table,
Add Data
o
Delete/Clear then:
o
Delete Line Remove the selected Freq/Value pair from the table.
o
then
Clear All Yes
o
header information to default settings.
Done to closes the Antenna/Cable Editor.
Save Antenna or
Storage Device. Enter a filename using the FieldFox labeler (learn more on
page 134). Learn more about Antenna and Cable files below.
Recall Antenna
the specified Storage Device.
Storage Device Changes the device used to save or recall files. Choose from
Internal (default setting), USB (must be connected) or SD card. This is a
different setting from the Save/Recall Storage Device setting.
is NOT the filename used to save the file.
NONE (default setting) to select from standard SA Units on the Scale menu.
Learn how on page 63.
Choose from: dB μV/m - (dB micro Volts per meter), dB μA/m - (dB micro
Amps per meter), dBG (gauss), dBpT (tesla).
to open the Antenna / Cable Editor.
Edit Cable
Edit
Quickly scrolls through pages of Freq/Value data.
Remove all Freq/Value pairs from the table and resets
Save Cable to saves your changes to the specified
or Recall Cable to load an Antenna or Cable file from
then modify the selected field
N9912A FieldFox User's Guide