Marker Format; Searching With Markers - Agilent Technologies FieldFox N9912A User Manual

When Coupled Markers is ON (NA Mode ONLY), this setting applies to the active
marker for ALL traces that are coupled. Otherwise, this setting applies to the
active marker on only the active trace.
How to move a marker between data and memory traces
 Create a data and memory trace that will host the marker. Learn how on page
 Press Marker and Enter to create a marker.
 Then
 Then select the marker to move using
 Then in CAT or NA Mode, toggle
 In SA Mode, toggle

Marker Format

The Marker Format setting is available in NA Mode in either Smith Chart or Polar
display format. Choose the format of the marker readout (upper right corner of
screen). Learn how to set display format on page 40.
How to choose marker format
 Press Marker
 Then
 Then
 Then choose from the following:

Searching with Markers

Marker Searches are used to move markers to locations on the trace which
exhibit the characteristics of the search criteria. Learn „What is a Peak‟‟ on page
128.
Data Analysis Features
132.
More
Auto - Marker resides on data trace when it is visible. Marker resides on
o
memory trace when only IT is visible (CAT, NA Modes ONLY)
Data - Marker resides on data trace, even when not visible.
o
Mem - Marker resides on memory trace, even when not visible. If a memory
o
trace is not stored, the marker moves to 0.0 dB at the same X-axis position.
Marker Trace 1,2,3,4
When a marker is moved to a „blank‟ trace (not visible) the marker moves to
o
the same X-axis position at either the Y-axis position of the last data, or to
the ZERO position.
More
Marker Format
(Magnitude and Phase)
Mag & Phase
Complex impedance format
R + jX
Marker 1,2,3,4,5,6.
Marker Trace Auto Data Mem.
125