Table of Contents
Advertisement
Triggering ................................................................ 76
Single or Continuous ............................................. 76
Resolution (number of points) ............................ 78
Trace Display States .............................................. 78
Averaging Type ...................................................... 79
Trace Averaging ..................................................... 79
Detection Method ................................................... 80
Display Line ............................................................ 81
Noise Marker .......................................................... 81
Band/Interval Power Marker ............................... 83
Frequency Counter at Marker ............................. 84
Audio Beep at Marker Power .............................. 84
Channel Measurements ........................................ 85
See Also
Markers .................................................................. 121
Limit Lines ............................................................ 130
Save Measurement Settings and Results ......... 134
SA Mode Settings
Select SA Mode before making any setting in this chapter.
Because there is no calibration, these settings can be made in any order.
How to select SA Mode
Press Mode_.
Then SA.
Frequency Range
The X-axis frequency range determines the frequencies that are measured for
each sweep. The default Start frequency is 0 Hz. However, the Start frequency
can be set as low as -100 MHz. The internal LO of the FieldFox can be seen at 0
Hz, which will mask signals that may be present.
SA (Spectrum Analyzer) Mode
Spectrogram Display ...................................... 94
Waterfall Display............................................. 97
Record / Playback ........................................... 98
59
Advertisement
Chapters
Table of Contents
