How To Save And Recall Limits - Agilent Technologies FieldFox N9912A User Manual

 Stop Frequency/Distance X-axis value for stop of line.
 Stop Amplitude Y-axis value for stop of line.
How to set Limit Options
 Press
 Then Options.
 Then choose from the following:

How to Save and Recall Limits

In addition to saving and recalling Limits with an *.sta file, Limit Lines can also
be saved and then recalled independent of the current mode or measurement.
Use this feature to recall and apply existing limit lines to measurements with
different settings or even a different frequency range.
Limit Line files can be loaded into the FieldFox Data Link Software. Learn how
in the help file that is included in the Data Link software.
How to Save and Recall Limits
 Press Save/Recall then
 Then press Limit .
 Then choose from the following:
Data Analysis Features
Limit table with two Upper limit lines. Warning ON.
Yellow circles and shading shows Start of lines.
Green circles and shading shows Stop of lines.
Exit if the Limit Table is visible.
Beep On Off Audible beep sounds when each sweep fails.
o
Shows
Warning On Off
o
sweep. Data points that fail are highlighted.
card, or USB flash drive) to be used for the Save or Recall. Learn more on page
136.
Pass or Fail indication on the display with each
to set the Device (Internal, microSD
Select Device
131