Agilent Technologies FieldFox N9912A User Manual page 149

 The left portion of the screen shows satellites and the corresponding number




GPS Status
With GPS enabled and a device detected, the following is displayed at the top of
the FieldFox screen:
In the above image, the following icons show if the FieldFox is locked on satellites:
Saving Data with GPS Enabled
GPS position and clock data are included when data is saved with the following
files types: *.csv, *.SnP, State, State+Trace data save.
A warning is shown if the GPS is ON but unlocked at time of save, or if the GPS
feature is ON but no GPS is physically present at time of save.
The following is a sample S1P file with GPS information:
!GPS Latitude: 38 28.87717 N
!GPS Longitude: 122 42.66625 W
!GPS TimeStamp: 06/25/2010 16:24:48
System Settings
on the adjacent Satellite Power chart.
Enable and disable the synchronization of the FieldFox
Sync Clock ON OFF
internal clock to the GPS UTC time standard.
ON The FieldFox clock is synchronized and updated approximately every
o
second to the time of the GPS clock. Learn how to set the local time zone on
page 150.
The FieldFox clock is NOT synched with GPS. When set to OFF after
OFF
o
Sync was ON, the date and time does NOT revert back to the settings before
the clock was synchronized.
Display ON OFF Enable and disable the GPS display on the FieldFox main
window.
Change the format of the GPS display on the FieldFox screen.
Lat/Lon Format
Choose from:
ddd°mm' ss.sss"
degrees, minutes, seconds (default setting)
o
ddd°mm.mmmmm'
o
decimal degrees
ddd.ddddddd°
o
Choose from:
Elevation Unit
(Meters)
m
o
Feet
o
- GPS ON and locked on satellites
- GPS ON, but NOT locked on satellites
- GPS ON, but no GPS receiver is present or detected
degrees, minutes, fractional minutes
149