Resolution (Number Of Points); Trace Display States - Agilent Technologies FieldFox N9912A User Manual

This setting determines whether the FieldFox measures continuously or only
once each time the
Single or to conserve battery power or to allow you to save or analyze a specific
trace.
How to set Single or Continuous
 Press Sweep 3.
 Then choose one of the following:
Resolution
Resolution is the number of displayed data points across the X-axis. The higher
number of data points, the better the ability to resolve closely spaced signals and
the slower the sweep speed.
How to set Resolution
 Press Sweep 3
 Then
 Then choose from:

Trace Display States

In SA Mode you can display up to four of the following types of trace states. All
SA settings are applied to all displayed traces.
A color-coded legend for displayed traces is visible in the left pane of the SA
mode screen:
W = Clear/Write; M = MaxHold; m = MinHold; A = Average; V = View
How to display Trace States
 Press Trace 6.
 Then
 Then
 Then choose from the following Trace States:
78
Single
Causes the SA to make continuous sweeps. This is the
Continuous ON
o
typical setting for making measurements. Each Run / Hold +/- press causes
the SA to toggle between continuous sweep and Hold.
Automatically sets Continuous OFF and causes the SA to make ONE
Single
o
sweep, then Hold.
Causes the SA to Hold. Each Run / Hold +/- or
Continuous OFF
o
press causes the SA to make ONE sweep, then Hold. The
changes to an arrow
Resolution [current setting]
101 | 201 | 401 | 601 | 801 | 1001
repeatedly to select a trace number to display. Traces are
Trace 1,2,3,4
displayed in the following colors:
Trace 1 – Yellow
o
Trace 3 – Orange
o
State [current setting]
or Run / Hold +/- button is pressed. Use Hold /
--> while the sweep occurs.
Trace 2 – Blue
Trace 4 – Red
.
Single
Hold annotation
N9912A FieldFox User's Guide