Wiring Harness - Rotax 912 i Series Installation Manual

5) Wiring harness

The wiring harness connects the engine control and the
- Control unit (ECU)
- FUSE BOX assy.
- Cockpit (switch, instruments, maintenance connection)
- Engine (sensors, injectors, ignition coils)
The sensors are fitted by BRP-Powertrain and connected to the wiring
Sensors
harness. The exhaust gas temperature sensors are included according to
the version or already fitted on GENUINE-ROTAX exhaust systems.
Install and lock the connectors of the ECU and/or FUSE BOX with gas-
ECU/FUSE BOX
connector
ket.
NOTE:
The HIC (Harness Interface Connectors) connects the cockpit instru-
HIC
ments and maintenance ports with the engine.
Connector
Graphic
Fig. 9
Effectivity: 912 i Series
Edition 1/Rev. 2
BRP-Powertrain
INSTALLATION MANUAL
The wiring harness must not be shortened or modified.
NOTICE
WARNUNG
Connectors with gasket difficult to push/pull.
Part
1 FUSE BOX X1 (LANE A), X2 (LANE B)
2 ECU connector A1, A2, B
3 Harness Interface Connector A, B
4 FUSE BOX X3
Function
24-00-00
January 01/2014
Page 19