Diagnostics; Firmware Update - Siemens SITOP UPS1600 Manual

3.4.6

Diagnostics

The following data can be fetched using the Diagnostics function:
Group
SITOP UPS1600 general
Fetching diagnostics data
You can use the "Station > Open online" menu command in "HW Config" to select the
SITOP UPS1600 and view the diagnostics data.
3.4.7

Firmware update

The SITOP UPS1600 is reset while updating the firmware. For safety reasons, the output is
switched off.
Ensure that no damage is caused to the plant or system.
Ensure that the PG/PC and/or all switches, routers and gateways that are used have an
independent power supply during the firmware update.
Firmware update with UPS-Manager
If for the firmware update, the UPS Manager is used, please note that for a firmware update
from version V2.1 to V2.2 or higher, then a UPS Manager with version V4.72 or higher must
be used. This also applies to firmware updates from V2.2.0 to higher versions.
Note
Install the current version of the SITOP UPS Managers, before you start the firmware
update. It is possible that an older version (less than V4.5X) of the SITOP UPS Managers
does not support this firmware update. The installation file for the SITOP UPS Manager is
available at no charge on the SITOP home page (http://www.siemens.com/sitop) or directly
(https://support.industry.siemens.com/cs/ww/en/view/75854607).
Note
Do not switch-off the devices during the firmware update.
SITOP UPS1600 / UPS1100
Manual, 04.2017, A5E37775406-8-76
WARNING
WARNING
Value
Article number
Serial number
Engineering and remote access
3.4 SIMATIC STEP 7
85