Siemens SITOP UPS1600 Manual page 56

Engineering and remote access
3.3 SIMATIC STEP 7 in the TIA Portal
Using an example, in the following steps, it is shown how the SITOP UPS1600 is assigned a
SITOP UPS1100 battery module.
Note
Only SITOP UPS1100 battery modules of the same type can be inserted into the slots of a
SITOP UPS1600.
The number of battery modules that can be configured is limited to six. The description is
only applicable to devices that were linked to via the HSP.
Preconditions
● STEP 7 in the TIA Portal has been opened and a project has been created.
● A SITOP UPS1600 has been integrated in the project.
Procedure
The procedure is only applicable for devices integrated via HSP.
For GSD devices, values can be manually specified for a (third-party) battery module;
however, it is not necessary to add a battery module to the configuration.
1. In the device view, select the SITOP UPS1600 basic device.
2. In the Hardware catalog , navigate to the SITOP UPS1100 battery module under Power
Supplies\SITOP UPS\UPS1100.
3. Select the required battery module in the hardware catalog.
In the "Information" area you can see information about the expansion module, and when
necessary you can change the preselected (default) version.
4. Drag the battery module and drop it into the Device view.
Alternatively, the battery module can be added by double-clicking on the entry in the
hardware catalog.
56
SITOP UPS1600 / UPS1100
Manual, 04.2017, A5E37775406-8-76