Siemens SITOP UPS1600 Manual page 134

Engineering and remote access
3.6 SITOP UPS Manager
Firmware update with UPS-Manager
If for the firmware update, the UPS Manager is used, please note that for a firmware update
from version V2.1 to V2.2 or higher, then a UPS Manager with version V4.72 or higher must
be used. This also applies to firmware updates from V2.2.0 to higher versions.
Note
Install the current version of the SITOP UPS Managers, before you start the firmware
update. It is possible that an older version (less than V4.5X) of the SITOP UPS Managers
does not support this firmware update. The installation file for the SITOP UPS Manager is
available at no charge on the SITOP home page (http://www.siemens.com/sitop) or directly
(https://support.industry.siemens.com/cs/ww/en/view/75854607).
Note
Do not switch-off the devices during the firmware update.
The files for updating the firmware (firmware updates) are available online under
(http://support.automation.siemens.com/WW/view/en/79207181). Different firmware updates
are offered depending on the amp rating of the SITOP UPS1600.
Note
Observe the compatibility of the firmware!
Other firmware updates are not compatible.
Determine the amp rating of your SITOP UPS1600 and download the appropriate firmware
update.
Note
It is not possible to downgrade the device firmware to a release with a version number lower
than the firmware installed in the device itself. Information on how to read out the firmware
release from the device is provided in Section Determining the firmware version (Page 132).
Note
"Reset to Factory" function:
All configuration parameters are reset to the default setting; 0.0.0.0 is used for the IP
address. A new IP address must then be assigned, as otherwise there is no connection to
the UPS Manager or TIA Portal.
See also
Display and visualization (Page 128)
134
WARNING
SITOP UPS1600 / UPS1100
Manual, 04.2017, A5E37775406-8-76