Usermanagement - Siemens SITOP UPS1600 Manual

Display name
AlarmBattery
TemperatureLow
AlarmFuseBroken
AlarmNewBattery
Detected
BufferTime
BufferingEndVoltage
ChargeCurrent
ChargeEndVoltage
ChargeTotalCurrent
ModuleCalculated
Capacity
ModuleCalculated
Health
ModuleCapacity
ModuleChange
Recommended
ModuleCompound
ModuleConnection
Fault
ModuleMax
Temperature
ModuleMin
Temperature
ModuleStandbyTime
ModuleStateLed
ModuleTemperature
ModuleTotal
CulledCurrent
3.8.6.22

UserManagement

Display name
AddUser
ChangeUserPassword Method
DeleteUser
UsermanagementUser
1 ... 16
SITOP UPS1600 / UPS1100
Manual, 04.2017, A5E37775406-8-76
Data type Definition
Boolean PropertyType
Boolean PropertyType
Boolean PropertyType
UInt32 AnalogItemType Desired buffering time before device switches off
Float AnalogItemType When battery voltage is lower than this voltage, the battery
Float AnalogItemType Actual charging current used to charge battery.
Float AnalogItemType Battery voltage when charging changes to trickle charging.
Float AnalogItemType Battery-specific data: Total charge to the battery during its
Float AnalogItemType Available battery capacity
Byte AnalogItemType State of health (SoS) as percentage of the rated capacity
Float AnalogItemType Capacity
Boolean PropertyType
Enumeration MultiState
DiscreteType
Boolean PropertyType
Sbyte AnalogItemType Maximum specified operating temperature of the battery.
Sbyte AnalogItemType Minimum specified operating temperature of the battery.
UInt32 AnalogItemType Battery-specific data: Time for which battery was connected
Object Sitop_1600_
LedType
Sbyte AnalogItemType Battery temperature
Float AnalogItemType Battery-specific data: Time for which battery was connected
Data type Definition
Method Method
Method
Method Method
SitopUserType SitopUserType
Description
Battery temperature too low - reduced output current
Fuse is defective.
A new battery was connected. The battery will be included
in the calculation of the total capacity and the charge pa-
rameters.
charge is no longer sufficient. Buffering is stopped.
Battery is charged 100%.
service life
Battery capacity is insufficient to achieve the specified buffer
time.
Connected device
Connection to battery interrupted - check connection and
fuse
but no power was consumed.
ModuleStateLed
and power was consumed.
Description
Adds a user.
Changes the password for the user.
Deletes the user.
Engineering and remote access
3.8 OPC UA server
179