Troubleshooting - Siemens SITOP UPS1600 Manual

Troubleshooting

You can obtain additional information on an active alarm from the help text.
The extended error type is used to interpret alarms in S7 function blocks that you have
programmed yourself.
The severity indicates the severity of the alarm:
● D = diagnostics
● MD = Maintenance Demanded
● MR = Maintenance Required
● F = Failure (module has failed)
Error Ex- Severity
Type tended
Error
Type
256 1 F
256 2 MR
256 3 MR
256 4 MR
256 5 MR
256 6 MR
256 7 MR
256 8 MR
256 9 MR
256 10 MR
256 11 MR
256 12 MR
256 13 MR
256 14 MR
256 15 MR
256 16 MR
256 17 MR
256 18 MR
256 19 MR
SITOP UPS1600 / UPS1100
Manual, 04.2017, A5E37775406-8-76
Alarm Text
Software corrupted
Wrong checksum
Parameter corrupt
Unknown parameter
Wrong message length
Wrong parameter
Command not accepted
Communication error:
Wrong length field
Wrong request
Cannot write to object
Object pending
Battery not available
EEPROM write error
Unknown alarm
Command outside range
Software update is being
performed
No software update
Wrong battery number
Wrong address
Help Text
Software is corrupt - try to update the software
Internal error: Communication disrupted
Attempting to write to an unknown or read-only object.
Attempting to set a parameter that is not known by UPS1600.
Internal error: Communication disrupted
Parameter value is not within the specified range
An incorrect command was sent to the UPS1600
Syntax error in command
Error in sent message: Unknown request sent.
Attempting to write a parameter that is "read-only"
UPS1600 cannot provide data for the requested object.
Attempting to access a battery that is not available. Either the
battery with the requested number was never connected or
communication with this battery was interrupted.
Saving UPS1600 parameters failed. Device is defective.
Internal error: Wrong parameter at execution of test command.
An incorrect command was sent to the UPS1600
The command sent cannot be executed as long as the pro-
gram is running.
Cannot execute the sent command because no software up-
date has been started.
Attempting to retrieve data about a battery which does not
exist or is not connected.
Wrong Flash address in software update - software update file
is corrupt.
4
183