Parameterizing The Ups1600 - Siemens SITOP UPS1600 Manual

Engineering and remote access
3.3 SIMATIC STEP 7 in the TIA Portal
3.3.7

Parameterizing the UPS1600

The adjustable parameters of the SITOP UPS1600 can be found in STEP 7 in the TIA Portal
in the inspector window under Properties when the appropriate device was selected.
For parameterization, in the area navigation, the settings under "Base Unit", "Energy
storage" and "Webserver" are relevant.
Navigation area
Profinet security
Navigation area
Base Unit
Energy storage
Web server
Navigation area
OPC UA server
Navigation area
NTP client
A detailed description of the individual parameters of the subgroups is contained in the
associated section under Parameterizing the UPS in STEP 7 in the TIA Portal (Page 58).
The procedure is the same for all parameters. This section describes the general procedure
to reach the configuration dialog, using as example the parameters for buffering. The
individual parameters and their possible values are described in the following subsections.
Each parameter has a start value. A click on "Reset to initial values" resets all parameters of
a subgroup to the associated start value.
Preconditions
● The SITOP UPS1600 was integrated in the opened project.
58
Description
Profinet security DCP write protection activated
Description
Buffering All parameters, which involve the behavior of SITOP UPS1600 when
buffering
Signaling Setting of the alarm signaling and the wait time for stable input voltage.
– Parameters for the battery modules used
General information Define as to whether the SITOP UPS1600 may be accessed via web
server (yes / no)
Activate web server on this module
Enable automatic logoff
Access with HTTPS only.
Automatic update Activate automatic update / Activation interval
Description
OPC UA server acti- Here, activate the OPC UA server.
vated
Unencrypted access You have the option of activating unencrypted access to the
activated OPC UA server. However, this option is not recommended.
OPC UA server port Specify which port should be used.
Description
NTP client activated Here, activate the NTP client.
NTP server Enter up to 4 addresses for an NTP server.
address 1 ... 4
SITOP UPS1600 / UPS1100
Manual, 04.2017, A5E37775406-8-76