Configuration Switch - Agilent Technologies 1260 User Manual

4
LAN Configuration

Configuration Switch

Configuration Switch

The configuration switch can be accessed at the rear of the module.
Figure 14
The module is shipped with all switches set to OFF, as shown above.
To perform any LAN configuration, SW1 and SW2 must be set to OFF.
N O T E
Table 15
Initialization ('Init') Mode
Link Configuration
60
Location of Configuration Switch
Factory Default Settings
Bootp, all switches down. For details see
selection"
speed and duplex mode determined by auto-negotiation, for
details see
on page 61
"Link configuration selection"
Agilent 1260 Infinity DAD and MWD User Manual
"Initialization mode
on page 65